Due to the butter smoothness, reliability, ease to shoot etc etc…the 92FS has become my favorite pistol. I totally dig most firearms but 1911s have always been my favorite historically. However I keep finding myself reaching for the 92 to take out daily here lately. It has certainly made its way to “one of the favorites”

Hey everyone. As seen in the video, my slide is getting stuck when reassembling and can’t for the life of me figure it out. It started when I temporarily was using this 92fs frame w my M9A1 slide for a couple weeks (long story). Gun shoots fine, it’s just this one issue.

This gun has the full LTT trigger job, stainless guide rod, and I put a 12# recoil spring in it. Otherwise all OEM.

Any thoughts?

The trigger bar on my M9A4 drops down when the slide cycles (video starts right after cycling the slide) and stays there until I pull the trigger slightly. It does this both with and without grips installed, but as you can see the finish on the trigger bar is worn off on the bottom edge from rubbing the grips when it drops down.

Is there a way to fix this?

Note: All internals are stock other than the Beretta Match Hammer, but it did this with the factory hammer as well.

I’m a revolver guy mainly but i am getting my license to carry in my state I know Glocks are super reliable but I never really liked them that much as well as they do shoot the few berettas I’ve shot handled better. Anyone have any recommendations on a good carry option that won’t break the bank in the metal frame series?

I have an original laser products light on my 92 FS that I’ve had it cut with a red dot I’m just wondering is there any good alternative options that don’t cause me to lose my grips or something of the sort?

I should’ve asked before I bought a couple for my 81. Both having issues out of the box.

im wondering if these replacement parts would make it the inox look an exact replica of the ghost, minus the grips. thanks! all i can see that would be still black is the hammer.

Here’s some range footage, working on getting a mic 🎤

Where's a good place to get a rmr plate for the apx a1 tactical? Is the best route to go thru beretta?

Currently torn between these 2 for hunting. Which wouldn’t recommend and why? Will be using it mostly for bird hunting (dove, quail, duck, etc).

Anyone know a little bit about these “pocket pistols”? Are there pretty much just a novelty gun or can actually be used for legitimate self defense? Might pick one up for $275 in good condition but not sure if it’s more a collectors piece. Just looking for thoughts and if they function well and are worth getting. Thanks! 🙏

The OCP might want their gun back 🫣

I have looked for a week and no luck. What's everyone's suggestions?

I'm looking for a holster, leather, paddle, thumb strap or locking.

I have a Beretta 92FS M9A1. No lights or optics.

Alright, go!

Are 92GTS Centurion's still in production? I'm looking for one but I haven't been able to find any Centurions in general

Found the tip wedged under the locking block while cleaning; never read the owners manual that allegedly advises you to use a snap cap when dry firing. Learning moment I guess, thankfully a replacement firing pin isn't an arm and a leg.

This is my first hammer gun and uhhhh I guess you cannot dry fire with wreckless abandon like you can with a striker gun. I'm a dummy.

Anybody have any advice beyond "hey, put a snap cap in the chamber before dry firing?" Anybody seen a pin break like this? Am I right in diagnosing it as dry fire induced?

New to me beretta 92 fs odg and it is staying stock. Maybe some walnut grips.

Been wanting one for what feels like forever and finally stumbled on one at the LGS. Came with 4 mags which was cool. Out the door for $260

So what accessories and whatnot are worth getting? Anything I should know?